Rapt Enterprises

Corporate

LINE OF PRODUCTS /SERVICES IN ELECTRONIC WARFARE SYSTEMS FOR MARKETING THE COMPANY HAS A LINE OF PRODUCTS and subsytems realised with current technology in RF / MW and analog / Digital devices upgradable to accomodate the advancement in device material technology with external agencies along with manufacture of Electronic Warfare and Jammer Systems The area are listed below: 1. Radio Frequency Fuses:Configureable for any Military Platform ,where terminal offensive is required . Can be done airborne platforms including missles .Operational frequency C,X,and KU bands 2. Phase coherent multi channel receiever channels for Direction finding applications on board surface platforms .Operational frequency 20 to 3000 MHz ,used for Communication intelligence gathering and target locating purposes. 3. Digital Instantaneous Frequency measurements (DIFM)receivers :usable in broad band Electronic Warfare systems used for tactical applications .Operational frequency P,L ,S,C, and KU bands . 4. RF front end receivers :Used for enhancing the sensitivity dynamic rane and selectivity of any microwave receiving systems and mainly used in RWR applications .Operational frequency :L,S,C, X,and KU Bands 5. Wide Band Tuners :This is usable in ELINT systems for interception of wide band signal wave forms. 6. Super Heterodyne Receivers :Can be used for intercepting sugnales with high senstivity .Typically finds use in ELINT sustems .FLIC has the product in the frequency range of X-KU Bands 7. Demodulators :Used for demodulating analog and FM in ELINT receivers .Operational Frequency 160MHz and 1 GHz 8. BITE Source:Used for testing operation ESM and RWR receivers 9. RCIED / Jammers :Used as pre-detonators for Remotely cntrolled Detonators 10. ECM / ECCM stimulators .Used for evaluation of ECM effectiveness of Jammers and ECM resilence of Radar Systems 11. Radar Warning Receivers (For Air borne application) MODE OF OPERATION FOR COLLLABORATION: Specific Products can be configured fron the listed areas to meet any customers requirements . Standard procedures are followed for design,simulation,prototype build,evaluate ,manufacture and document. Alternatively the Technology transfer route can be followed and help in developing and manufacturing. Assistance in complete trasfer of relevant technology can be done and do hand -holding till the successfull production.